"Shuttio can no longer reach" your source or destination
The connection to your source or destination was disconnected or its access was deleted before the run ended. Reconnect from the card on the run page.
Last updated: 15 November 2026
What you see
The run page of an unfinished migration says "Shuttio can no longer reach", the lost system's name and "Reconnect it to continue.", above one card per lost system. If both ends were lost, the names are joined with "and", for example "HubSpot and Attio", and the sentence ends "Reconnect them to continue."
Why it happens
Shuttio's access to the source or the destination was disconnected or deleted before the migration finished, or the provider refused it mid-run. Without it Shuttio cannot read from or write to that system, so the run cannot continue.
A finished, failed or cancelled migration shows a different sentence: Shuttio deletes its access 14 days after it finishes. See Source and Connect.
How to fix it
- On each card, press the button named "Reconnect" plus the system, for example "Reconnect HubSpot", and connect it again. The ways to connect each system are in Source and Connect.
- Reconnect the destination workspace or account the migration already wrote to. A different one is refused and nothing is saved. For Attio the refusal reads: "This migration wrote to a different Attio workspace."
- If the run is paused after you reconnect, the page can say "Reconnected, but the run did not resume" with the reason. Press Resume.
- After the run finishes, press "Retry all errors" only if the Errors tab lists failed items. How Retry all errors works.
If the card does not clear after you reconnect, email help@shuttio.com with the migration ID shown under the page title (it starts with "MIG-").
Not answered here? Email help@shuttio.com.